jay (support) wrote:jay (support) wrote:You use the Interfaces->INSTEON/X10 Power Line->Set Motion Sensor Timeout... menu item to adjust it.
Note, however, that the new motion sensor seems to use a slightly different scale (I'm trying to get the specifics from Insteon now). Setting it to 0 does appear to set it to 30 (default). However, setting it to 1 sets it to about 10 seconds, 2 to 20ish, etc. So you may have to play around a bit to get it set to the duration you want.
Just to follow up - the setting is now in 10 second increments (0 still defaulting to 30). So 1=10 seconds, 10=100 seconds, etc.
gabbas wrote:Has anyone had any luck turning off the LED on an MS II 2844-222? I tried the "Set Motion Sensor LED Brightness..." menu item and if I power the motion sensor by USB then the command is acknowledged, but it still flashes the LED whenever motion is detected.
Sent INSTEON "motion sensor" raw insteon command (20 02 00 00 00 00 00 00 00 00 00 00 00 00 00 DE; ack: 02)
gabbas wrote:Thanks Jay!! I tried it out... had to hook the motion sensor up to USB power so that it would receive the command, and then it worked:
- Code: Select all
Sent INSTEON "motion sensor" raw insteon command (20 02 00 00 00 00 00 00 00 00 00 00 00 00 00 DE; ack: 02)
... but the LED is still flashing. Do I have an old revision maybe? I got mine back in May 2017... it reports "Firmware: 46 (i2CS engine)".
matt (support) wrote:Choose the Interfaces->Insteon->Execute Raw INSTEON Command... menu item, then fill it in so it matches the image below exactly, except choose your motion sensor device from the popup.
Note I just added the 0x (zero and x) character to the front of every 2 hex digits. You have to enable the Send extended message checkbox, then expand the height of the window downward to see the D1 to D14 edit fields. You'll need to wake up the module (probably just put it into linking mode) so that it can see the command. Watch the Event Log window when you press the Execute button. If it doesn't work then copy/paste the contents of the Event Log window into a reply.
Dec 11, 2018 at 9:01:06 PM
Received INSTEON "motion - office new" off (button 13)
Sent INSTEON "motion - office new" raw insteon command (20 02 00 00 00 00 00 00 00 00 00 00 00 00 00 DE; ack: 02)
Dec 11, 2018 at 9:02:42 PM
Received INSTEON "motion - office new" off (button 16)
Received INSTEON "motion - office new" on (button 16)
Received INSTEON "motion - office new" off (button 1)
Received INSTEON "motion - office new" on (button 1)
Sent INSTEON "motion - office new" raw insteon command (20 02 00 00 00 00 00 00 00 00 00 00 00 00 00 DE; ack: 02)
DPattee wrote:Same firmware 46 on the one I'm testing with. I've "successfully" sent the command twice, but the light still flashes.
Sent INSTEON "New Motion Sensor" raw insteon command (20 02 00 00 00 00 00 00 00 00 00 00 00 00 00 DE; ack: 02)
Users browsing this forum: No registered users and 3 guests