Hi all,
I've cross-posted this with the Cynical Behaviors section.
My Cynical Garage Door* has started reporting a reversed state, when it's added as a Garage Door device. When it's added as a simple switch, it shows "Off" when closed, "On" when open. (Reflecting the state of the tilt-sensor?)
I've turned on "Show All Options" and tried my way through them** without obvious success.
Is there an option/trick to causing the Indigo-side to reverse reporting? The family uses Home, I can tolerate Indigo showing something else.
Thanks,
Ben
*My Cynical door uses these Z-wave devices:
Zooz Zen16 relay (#1, set to momentary)
Ecolink tilt sensors
**This process may've been imperfect: I'm uncertain if I waited long enough between unpublish-republish times. There are attempts where the republish never succeeded.