How do I dim a shelly Dimmer 2
Posted: Sun Sep 10, 2023 6:06 pm
I have a Shelly Dimmer 2 setup using ShellyMQTT. It works just fine using the on/off buttons and the brightness control in the device details display in Indigo. I don't have any physical switches connected to the Shelly Dimmer switch. I want to control it entirely wirelessly. This going to replace a bare bulb, with a chain pull, to turn it on/off, with a new dimmable LED panel that is controlled by the Shelly Dimmer 2.
I have a SwitchLiinc2 remote setup so that when I press button group 1, it turns the light on/off. The shelly is configured so that it comes on at it's last brightness value. This all works.
Now I would like to control the brightness. The SwitchLinc2 sends a Start Brighten/Dim command when you hold down the group 1 button, but Dimmer2 doesn't show up as a target for that command in the action section of the trigger.
Any hints on how to make this dim/brighten without scripting a loop to increase/dim the brightness?
I have a SwitchLiinc2 remote setup so that when I press button group 1, it turns the light on/off. The shelly is configured so that it comes on at it's last brightness value. This all works.
Now I would like to control the brightness. The SwitchLinc2 sends a Start Brighten/Dim command when you hold down the group 1 button, but Dimmer2 doesn't show up as a target for that command in the action section of the trigger.
Any hints on how to make this dim/brighten without scripting a loop to increase/dim the brightness?