I have several virtual devices set up as alarm zones. Essentially they aggregate (OR) the state of the sensor or detector devices in their zone. I then am using triggers to monitor the state of the zone virtual devices and set a fault variable if the zone state changes to ON.
During testing, I noted that two of the virtual zone devices would never move to the ON state. Upon further investigation of the log file, it appears that an error occurs for both of these virtual devices whenever an included real device changes state. I have attached snips of the log below.
I have a third virtual zone device that is implemented in an identical fashion to the two that are failing, but it seems to work fine. It monitors 3 TriggerLinc devices on a different floor.
I am running Indigo v6.0.3 on a Mountain Lion system.
Any ideas?