I'm certain that the URL format is as such:
- Code: Select all
http://IP:PORT/snapshot.cgi?user=admin&pwd=password
This works fine in a browser and in an Indigo control page refreshing image URL.
But I can't get it to work with Security Camera Plugin.
I've tried urllib and urllib2 (with the login info blank).
Turning on debug doesn't show any errors. Foyer is an old Vera Vistcam (rebranded Foscam) and it works fine. IPCam2 is the new addition.
- Code: Select all
Security Camera Debug Starting main loop
Security Camera Debug Starting Carousel
Security Camera Debug Starting Master Image
Security Camera Debug Unable to run Master Image
Security Camera Debug Starting Device Loop
Security Camera Debug Starting Device Loop for:Foyer
Security Camera Debug Set State Timers
Security Camera Debug Get Camera Image
Security Camera Debug Check Motion
Security Camera Debug Starting Device Loop for:IPCam2
Security Camera Debug Set State Timers
Security Camera Debug Get Camera Image
Security Camera Debug Check Motion
Any advice?
Another nugget of info. Using curl in a terminal with the above URL also works just fine.