- Posted on
Fri Jan 15, 2016 3:19 am
-
petematheson
offline
-
- Posts: 847
- Joined: Sep 14, 2014
- Location: Southampton, UK
Thanks Peter - I've had to disable use of this for now as it's leaving my zones on permanent heat all day.
My understanding is that I should be able to use motion sensors to use the 'Set Hotpoint' command to say, set that Zone at 19 Degrees.
When I check the Evohome controller it then shows this as a permanent over-ride.
So then my 'Cancel zone override' that's delayed by 20 minutes should then remove this permanent override and set the system back to whatever schedule it was set to before.
All of the motion sensors / permanent triggers seem to work fine, it's just the cancel override that doesn't always seem to trigger. (It sometimes does, but often doesn't)
When I manually run the action, again it sometimes works but sometimes doesn't.
I guess I could come up with some logic that says if a cancel override job has run, but it's state is still permanent override then run the same action again until it's successful ?