Page 1 of 1

weird Problem with V7.115.326

PostPosted: Sat Dec 14, 2019 12:20 pm
by johnpolasek
I just upgraded from whatever was running last July (been busy, so missed a few intermediate ones) and have a VERY weird problem; I have 5 rPis scattered throughout the house, and after the update, all but the last one (PI-4) are gone from the device list and are no longer detecting beacons... BUT the Pi-0 and Pi-3 that have contact closures on their GPIOs are continuing to report changes to those devices. In the plugin, the only PI that is available for configuration is PI-4, but the Indigo log keeps reporting
    piBeacon Warning RPI# X check , too many empty messages in a row: 2
    piBeacon Warning sending reboot command to RPI
for all the missing Pis... When I tried to add one of the ones with no GPIO's attached back into the list as a new PI-1 by IP, it will not find it.

Any suggestions about how to get them back without losing the 2 dozen GPIOs I have attached?

weird Problem with V7.115.326

PostPosted: Sat Dec 14, 2019 4:44 pm
by kw123
Switch off reboot in config.

And can you or ssh to the rpi?

AND PLEASE RETAIN THE PLUGIN.LOG files I need to see the log statements when the rpis diSappeared

.. also please check the mail I send

Sent from my iPhone using Tapatalk