Arduino Temperature Sensor

Plugin to facilitate the communication (read/write/set PIN config) between INDIGO and an ARDUINO through WiFi/ETHERNET. Included is an example “SKETCH” for an ARDUINO that should work without modifications.
mpleeds
Posts: 58
Joined: Mon Jul 02, 2012 4:51 pm

Arduino Temperature Sensor

Post by mpleeds »

Hi,

I have been using the Maverick BBQ thermometer (with external probe) via RFXCOM with limited success to monitor my sauna temperature. The primary issue is that because of the distance from my RFX transceiver, it sometimes loses signal strength and stops reporting. I'm wondering if an Arduino sensor through WiFi or Ethernet may be a more reliable and cost effective solution. Not having a lot of free time nor a background in engineering / programming, would it be realistic for me to implement this? Any suggestions and/or list of required components would be welcome.

The prerequisites for a sauna temp sensor would be:

1. Ethernet or Wifi.
2. Temp range up to 75° C.
3. Reporting at least every 10-15 seconds or upon change.

Thanks,

Merrill
peszko
Posts: 325
Joined: Wed Mar 07, 2012 5:37 pm

Re: Arduino Temperature Sensor

Post by peszko »

I'm looking for a similar solution for my sauna and pool. Currently I'm using Insteon thermostats where I replaced the internal temperature sensor with an external one (some soldering required). It works, but its a bit unwieldy and not super reliable. I'm also trying to move away from insteon and would really like to find a z-wave device.
Post Reply

Return to “ARDUINO Plugin”