No ack but does work

Hi All,

I have a fibaro dimmer that is about 2m away from the z-wave controller.
Commands sent to it always work, but it shows a constant state of no ack in Indigo.
If I hammer the send status request and send on / off commands to it, one of two of them will report back to Indigo and take it out of the no ack status, but then the next command will.

Suggestions please?

[matt (support)]

I would try exlcuding the module from the Z-Stick, then re-including it. Next, open the Define/Sync dialog in Indigo, select the new node ID for the module (it might change after the exlcude/include), then let Indigo re-Define/Sync it.

If that doesn't help, then copy/paste the contents from the Event Log that illustrate the problem.