Can either of you point me toward the proper setup and use of the plugin.
My Autelis arrived and I'm able to reach the Autelis to see and control the pool pump along with seeing water and air temps via Safari on the LAN, but the plugin doesn't seem to be able to see or control the pump nor report temperatures.
The Model number of Autelis is "SN100" in case it's new or different from what was shipped to you.
Autelis Plugin Setup as below:
IP: set to "10.0.1.112" (which is assigned to the Autelis MAC address by router). I use 10.0.1.112 in my browser to login and reach the Autelis successfully. Using the default login & password for the Autelis, but that was not entered into the plugin during setup.
Port: left at "80"
Number of AUX units. I've tried between 1 and 15 and left the names the same, then remaned them to exactly match what I see on the Autelis local website at 10.0.1.112 via browser.
I see the following relevant messages in the log at Indigo startup (and no other Autelis messages):
Loading plugin "Autelis Jandy 1.0.5"
Starting plugin "Autelis Jandy 1.0.5" (pid 925)
...
Plugin "Autelis Jandy" connected
...
Plugin "Autelis Jandy 1.0.5" started
...
Autelis Jandy Saved Plugin Configuration
Autelis Jandy Socket: 10.0.1.112:80 connected succesfully
In Indigo, I created an Autelis Plugin device: Type: Plugin -> Plugin: Autelis Jandy -> Model: Autelis Controller. I also created an action group to turn off the pump. When I execute the action group, I see the following in the log:
Action Group POOL PUMP OFF for 15 MINUTES
Autelis Jandy Socket: 10.0.1.112:80 closed succesfully
Autelis Jandy Socket: 10.0.1.112:80 connected succesfully
Nothing happens, the pump keeps running. Have waited few hours to see whether it would update temps in Indigo, but has not.
Any suggestions or pointers would be appreciated. Thanks,
mjc