I'm about to install a bunch of these throughout the house too and would love to figure out a way to control via Indigo.
So far I haven't found a lot on the web where people have done this. There's an inactive thread on the smartthings forums -
https://community.smartthings.com/t/kum ... -air/46525 - where they at least made a start at reverse-engineering the control codes. It would seem that since there's now a web app for controlling this stuff it should be possible to track things down a little easier?
It's been way too long since I wrote code so I'm hoping someone else out there might be tackling it already but otherwise I may have to dive in once my units are installed.
Incidentally, one other point of information is that there are two different wifi controllers out there for this:
Wi-Fi Adapter (PAC-WHS01WF-E) older model, Requires WPS
Wi-Fi Adapter (PAC-USWHS002-WF-1) Newer Model, does NOT require WPS
I'm assuming everybody getting a new system will be getting the newer model controller.
(I also changed the subject of this thread to include keywords 'Kumo Cloud' which is what Mitsu calls this protocol... in case someone comes searching for it).