Hi all,
I installed last week a Fibaro switch to control lights in the bathroom during night (only if variable night=true).
It works without any problem when motion is detected but I am not 100% satisfied with my setup.
I have a motion sensor (Fibaro) in the hallway and when I exit my bedroom, the motion sensor sees me and switch the light on.
Then the light stays on for two minuts and the goes automatically off, but it could happens that I am still in the toilet
The motion sensor has also a "dead time" of 30s, if I remember correctly; it is marked as ON but does not send and trigger.
How can I modify my scenario?
I think the only possibility is to put a motion sensor in the toilet, right?
Thanks
Marco