Strange problem with shadows

Hi all,

I do not know where to post this message as I have not understood the problem yet.

This scenario happens with two shadows only (among 5); I have a schedule running in the evening that closes all the shadows (I uses the Fibaro Roller Shutter).
Then of course the switches on the wall (two switches, up and down) are maybe in the "wrong" position (it depends on the last command you did with the switch itself).
If a press the button to go down (even if it is already completely down) it does nothing for a couple of seconds, but the the shadows go completely up...why?

From the Indigo logs I cannot yet understand what going on.

Do you have an idea?

Thanks
Marco

Can you post the logs of these actions happening?

Are the parameters (and firmware levels) all set identically on all five devices?

I also tried with a third roller and it happens. With the fourth it doesn't, with the fifth haven't tried

I was in front of the log when my wife was trying (not so happy eheheh ) I did not see anything about devices changing their states.
I will try again in the weekend with more calm

Thanks