Hi all, I've updated the code to fix the "unknown zoneState" error, e.g:
Error cannot update device state for key zoneState to value unknown (invalid enumeration value)
Pull from
https://code.google.com/p/py-concord/, or
https://dl.dropboxusercontent.com/u/138 ... 0.3.tar.gzRegarding your other comments wire3d, I have to admit I am not incredible knowledgeable about all the installation vagaries -- my alarm was not installed by me and I don't have the installer code. I guess my installer defined all partitions because the alarm panel wants to tell Indigo about them in my system. I know am a bit late here but I don't suppose you can show me what the errors about non-defined partitions looked like? (i.e. the message)
I'll have to dig into why when there is missing zone text there are other problems --- should just ignore that and make up a name (e.g. Zone 4).
Regarding arming, my panel is set to allow quick-arm -- and I think that's the only way it will work, as the panel does not seem to accept many kinds of keypress sequences via the module. E.g. I can't seem to do any sequences that would entail navigating the menu structures, like changing the volume of the voice module, etc.
And for the log output at the bottom, I am not exactly sure. Looks like a state change first (latchkey off) -- someone pushed a button or otherwise turned off the latchkey mode. And the last two parts are something happened to cause you system to turn on outputs 5 and 6 -- but I couldn't tell you *why* -- maybe how it's configured?
How does alarm.com interface to your panel? Over the phone?
Hope that helps a small bit.