Z-wave and X10 RF interfaces stop working

My z-wave and X10 RF interfaces stop working every few days or so, but not at the same time. The interface device still shows up in the settings and there are no errors; it just stops working. I think this started when I updated to 2022.2, although I'm not sure of that. It could have been related to MacOS 13.2.

I fix it by reloading the z-wave interface or disabling/enabling X10 RF. For z-wave, I do this with an action every night so it seldom fails. However, I have to keep checking X10 sensors to see if they are updating so I can reset the interface manually.

So, 2 questioins:

1. Is there a way to automatically reset the X10 RF interface?
2. Is there any way to investigate why this is happening?

Thanks.

--Dave

[jay (support)]

1) Unfortunately, no.

2) When you notice this behavior, what does the progress bar in the lower left corner of the Mac Client's Home Window look like? Is it all green indicating it's backed up? If not, when you try to turn on/off a device from the Mac Client, do you see green bits going left to right (indicating sending) followed by purple bits going right to left (indicating receiving)?

Thanks, Jay. I'll let you know next time it happens.