Z-wave Door Sensor ZD2102 Error validating fields
Posted: Sat Mar 27, 2021 11:40 am
I get the following error whilst configuring a ZD2102 Door/Window Sensor setting the External switch broadcasting from Enabled to Disabled:
From the manual, parameter 001 is 0 when disabled and 255 when enabled.
I can set this via Z-Wave > Modify Configuration Parameter... and everything works just fine, so this is a form validation error when setting to Disabled.
- Code: Select all
parm 001 value is too small (value cannot be less than 1)
From the manual, parameter 001 is 0 when disabled and 255 when enabled.
I can set this via Z-Wave > Modify Configuration Parameter... and everything works just fine, so this is a form validation error when setting to Disabled.