Indigo Domotics

I have two Insteon devices on one circuit (in one wall box) that respond to commands/queries about 10-15% of the time, yet manually activating the device always gets posted to the log. Any idea what the problem could be?

Code: Select all

Sep 12, 2020 at 08:59:01
   Error                           "Outside:  Front Porch Lights" off; send failed (no acknowledgment)
   Error                           "Outside:  Front Porch Lights" off; send failed (no acknowledgment)

Sep 12, 2020 at 08:59:27
   Received INSTEON                "Outside:  Front Porch Lights" off

Sep 12, 2020 at 09:00:07
   Error                           "1st Floor Hall Lights" status request; send failed (no acknowledgment)

Sep 12, 2020 at 09:01:31
   Error                           "1st Floor Hall Lights" status request; send failed (no acknowledgment)

Sep 12, 2020 at 09:03:47
   Received INSTEON                "1st Floor Hall Lights" off
   Received INSTEON                "Outside:  Front Porch Lights" on
   Received INSTEON                "Outside:  Front Porch Lights" off
   Received INSTEON                "1st Floor Hall Lights" on

Sep 12, 2020 at 09:04:21
   Error                           "1st Floor Hall Lights" status request; send failed (no acknowledgment)

Sep 12, 2020 at 09:04:37
   Error                           "Outside:  Front Porch Lights" status request; send failed (no acknowledgment)



Signal noise of some kind is the most likely culprit (despite the behavior). You can try to resync them and make sure that there aren't any errant inter-device links (specifically to devices that don't exist any longer). But signal noise is almost always the issue with situations like this.

Thanks, Jay.

The microswitch in one of them is getting hard to activate; both are powerline only. I'm going to replace it with a dual-band device and see if that helps.