Somfy with Fibaro FGS221

Posted on
Thu Jun 13, 2013 4:55 am
IanLJ offline
Posts: 12
Joined: May 14, 2013
Location: Netherlands

Somfy with Fibaro FGS221

photo3.JPG
Somfy controller & Fibaro FGS221
photo3.JPG (156.15 KiB) Viewed 4579 times


The back side of the Somfy controller with the wires hooked up to the Fibaro.

photo2.JPG
Wires connected to the three switches on the Somfy controller
photo2.JPG (137.86 KiB) Viewed 4579 times


Soldering of the wires to the print of the Somfy controller. The buttons on the Somfy remain fully functional.


photo1.JPG
Wires hooked up to Fibaro FGS221
photo1.JPG (138.04 KiB) Viewed 4579 times


The green wires are currently not used. Just put them there for future use, or if I come along a triple relay switch.
Mass from the UP and DOWN switches are joined into IN on the Fibaro FGS221, the corresponding connecting wires to O1 and O2.

Hooking up to Indigo was easy. The auto off delay for both relays I set to 5 which is about half a second. If you need more info let me know!

Oh, and of course, be careful and take good precautions. I will place the Fibaro in a special plastic casing and mount the Somfy controller on top. The setup on these photos was for my proof of concept.

Page 1 of 1

Who is online

Users browsing this forum: No registered users and 3 guests