get temperature from Aeotec Water Sensors 6

Hello.

Adding an Aeotec Water Sensors 6 as a device creates four devices: Water Sensor, Temperature, Tamper, and Tilt.

I have a trigger type "Z-Wave Command Received" with the event "Incoming Command Received from Device." I would like to have the Condition compare the "Sensor Value" from the Temperature "device" to a variable, e.g., a variable holding a minimum temperature for the house.

Can anyone suggest Python code to get the temperature from the Aeotec Water Sensors 6? I cannot figure that out. I should be able to do the rest (get variable, compare, etc.).

Thanks.

[matt (support)]

I know you've already seen the reply, but for completeness just wanted to point this thread over to here where this question was answered.