Creating variable script to operate within control page

Posted on
Mon Mar 02, 2020 6:26 pm
Eagleye offline
Posts: 25
Joined: Jan 14, 2019

Creating variable script to operate within control page

I was wondering if it is possible to add indicator lights to control pages that turns on when certain trigger conditions are meet?
E.g. I have a "Plug-in Smart Switch 6" connected to a power outlet that monitors power usage to a submersible in-ground water tank pump. I know when the pump is operating, because the power usage increases.
I would like to add an indicator light to my control page that turns on when power usage reaches a certain level and then off when it drops below another level.

I though variables might work here, but I have limited knowledge in this area.

Page 1 of 1

Who is online

Users browsing this forum: No registered users and 1 guest