- Posted on
Thu Jul 20, 2017 5:01 pm
-
Japple55
offline
-
- Posts: 224
- Joined: Sep 26, 2015
- Location: NE Tennessee
Good ideas, Jay. I do have Home Remote installed but didn't think I had any actions active, but it is showing up in the log. The log shows the command sent, and then one minute later the HR action. Can the action be executed and take a minute for the request to show up in the log?
Jul 20, 2017, 4:30:00 PM
Schedule Update Temperature and Humidity
Action Group Update Temp & Humidity
Z-Wave received "Kitchen Motion Sensor" status update is on
Trigger Kitchen Lights ON via Motion Sensor
Z-Wave sent "Kitchen Lights Dimmer" on
Z-Wave received "Kitchen Motion Sensor" status update is off
WebServer request to turn on device "Garage Door Controller (GD00Z-4)" from 70.88.60.130
Z-Wave sent "Garage Door Controller (GD00Z-4)" open
Z-Wave received "Garage Door Controller (GD00Z-4)" status update is opening
Z-Wave received "Garage Door Sensor" status update is on
Trigger Garage Door OPEN - Push Notification
Trigger Garage and Driveway Lights ON
Action Group Garage and Driveway Lights ON
Pushover Debug
Pushover Debug Garage Door is OPEN
Pushover Debug
Pushover Debug
Z-Wave sent "Driveway Light" on
Z-Wave received "Garage Door Controller (GD00Z-4)" status update is open
Jul 20, 2017, 4:31:01 PM
WebServer request to execute action group "JIM Location Variable set to AWAY" from 70.88.60.130
Action Group JIM Location Variable set to AWAY
Z-Wave received "Kitchen Motion Sensor" status update is on