I have 4 images, one for each room I have a Stella-Z in, and I'm using the following in the control page:
- Code: Select all
Display: Device State
For: Living Room Stella Z Conroller
Mode (on or off)
As image: HeatingPage_LR+.png
I therefore have another image in the same folder called HeatingPage_LR+on.png and the same again for the other 3 rooms with corresponding names, MB instead of LR and so on.
Indigo is just not updating the image when the state becomes ON or OFF correctly. I've duplicated the image and changed it from image to text to check what the output is displayed as, and to check that it's updating the actual devices correctly when I change what the devices is doing. There are 3 states: Off, Heat Pending, and Heat On. Do image names have to match what the devices would display as text? Because I've tried that and that doesn't appear to make a difference. I've also tried true/false, on/off, both of which also had the base image with just the … +.png - but that didn't work either. I've also rebooted the server multiple times to see if things were being cached, all to no avail. I've created a test page and added the devices again and they still don't update correctly - sometimes it does but doesn't go back to the off image. Sometimes the on image is shown instead of off when the Stella is off.
Ideally I would like it to reflect all 3 states: Off, Heat Pending, and Heat On, but I can't get this on/off to work correctly so I'm stuck. All the other images I've made for this work just fine. for example, I've made a Boost icon which similarly has a Mode (on or off) and corresponding HeatingPage_Boost+.png and HeatingPage_Boost+on.png and that works just fine. Could if be something to do with the Heat Pending state? But once it becomes on surely the …+on.png image should be used.
Well and truly baffled.
Simon