1. I strongly recommend you download the preconfigured SSD posted on the pibeacon page
there is a section on how to make the SSD, if you use your own you will need to install a bunch of libs - described in how to ..SSD
2. you can set your wifi info on the preconfigured SSD so that the RPI auto connects to your Wifi, check the post for that
3. insert the ssd and start the RPI.
and find the IP# of the RPI
4. ssh to the PRI and set your password ( > passwd to set it) default is pibeacon and in sudo raspi-config set your timezone.
reboot
5. in the plugin
in config set basic parameters: userid of indigo, and allow new beacons, you can leave most at default
then in menu "initial setup of RPI .."
there you enter the IP# user id password of your RPI
save
The rest should be automatic
the plugin will maintain software versions on the RPI (not the OSS)
it will update configs etc on the RPI
if setup correctly you should see a lot of beacons pop up. - People that walk by w a tracker on their key etc..
Then you should switch off accept new beacons in config.
How to determine which is your beacon, see the discussion topic in pibeacon.
And I also strongly suggest to have at least 2 RPI that "see" each other = in range of bluetooth of each other
Basically follow post #,1,2,3,4,5,... in that sequence at
https://forums.indigodomo.com/viewforum.php?f=187Hope that helps.
Karl