- Posted on
Mon Mar 06, 2017 6:15 pm
-
Bleasel
offline
-
- Posts: 88
- Joined: Mar 05, 2014
- Location: Sydney, AUSTRALIA
I just used the "Request Support" link on the homepage. (Not the forum site). They responded in 24 hours.
I was not able to find anywhere how to update the firmware, or indicate the latest firmware. Some sites say it happens automatically, and it obviously does as I had v180, however I note from the forum site there were discussions (including from you) in respect of the 616 cmd midway through last year.
Re the access code. A work around may be: in the Config include a check box for access code required for *1, *2, *3
and in in the plugin use and "if statement", such that if checkbox has been check, then use the *1[code] etc.
Sorry my python is very basic, but that would work using basic coding. It is not the universal solution that you are proposing, but then again, perhaps the master code should not be inserted in all situations when requested by the plugin, particularly as there is no way at this stage to limit control pages or features to particular users.