Indigo Domotics

Hello,
I have tried to connect to an EasyDAQ DO24PRMx-2Stack using Indigo v 6.0. So far, I've been less than successful. There is no specific pull down for a 48 relay stack in the menu. Using the 24 relay pull down, and attempting to activate relay #1 will activate relays 1-16 on both boards. Disconnecting the second board yields the same result with only board #1. Attempting to activate any other relay does nothing either alone or in concert with relay #1.

Do I have a driver problem or a hardware problem?

Thanks,
Tom

Hi Tom,

So turning on just the 1st relay really turns on the first 16 relays of both boards?
And turning on the 2nd relay (or 3-24) does nothing at all?

I do see in the dev documentation it says, "USBDO96 card uses the same commands but uses a latching function. Email for more details." I don't know what that means exactly, but I'll see if they can provide more details.

So turning on just the 1st relay really turns on the first 16 relays of both boards?
And turning on the 2nd relay (or 3-24) does nothing at all?

Yes, at least the indicator LEDs come on, I haven't actually tested any but #1.

Tom

I've emailed the EasyDaq folks. I'll let you know what I hear back.

Indigo v6.0.13 is now available for download and includes support for EasyDAQ DO24PRMx stacks — up to 96 relays on a single USB port.

Thanks Matt,
Everything is working great!
Tom