I have been using Indigo to control multiple insteon devices (>60 after major renovations) for several years, and have found it a considerable step up from my old X10 system. I recently decided to try and use some of the old X10 wireless controllers that I have, which in some ways are nicer than the currently available insteon devices. I plugged in a RR501 transceiver module and was able to control X10 devices and send commands to Indigo right away (also works with a CM15A). So I wrote some triggers to control insteon devices and they work just fine - for example:
Received X10 ------------- A7 on
Trigger ---------------------- X10 A7 Lights On
Sent INSTEON ----------- "Dining Room Main" on to 40
Then I wrote a trigger to activate a scene I commonly use, and got a very strange result - the commands keep being sent over & over (like an infinite loop). The only way to stop it is to send another insteon device command from the console (several times). Log looks like this:
Received X10 ------------- A7 on
Trigger ---------------------- X10 A7 Lights On
Sent INSTEON ----------- "PowerLinc Interface" on (scene 1 - Downstairs Low Light)
Received X10 ------------- A7 on
Trigger ---------------------- X10 A7 Lights On
Sent INSTEON ----------- "PowerLinc Interface" on (scene 1 - Downstairs Low Light)
Received X10 ------------- A7 on
etc., etc.,etc.....
I tried adding a simple action after the scene action, but that just gets repeated too. Any idea what is going on and how to fix it?