[ANSWERED]image renders different on web server and Indigo T

I have come across something strange. I have a status image of my house. I then have a png layer that indicates if there is a light on in the 3 rd floor, kitchen and living room.

The strange thing is that the 3rd floor and living room layers are displayed different on the webserver and the iphone app.
See the examples below. I have adjusted it so that the "light" fits the windows on the touch app, but it would be better if they aligned up equally.
The strangest thing is that I dont have this issue with any other images.

Any suggestions?


Håvard

I tried to do the whole process again. And this time it worked. I am not sure what did it. But it works now...

Håvard

I tried to do the whole process again. And this time it worked. I am not sure what did it. But it works now...

Håvard

Nice effect!

I have something similar happening on one of my control pages. Did you completely rebuild the page from scratch?
Dave

I only created new layers. And replaced the png. I have a layer for garage open close also


Sent from my iPhone using Tapatalk

Thanks Håvard.

I figured out my situation as well. On a whim, I deleted the image in question from the control page and then reinserted it. This cleared up the problem.

I think I know what caused it (at least in my situation.) I had reduced the size of the source PNG file and reloaded the server to load the new image. However, the handles on the image within the control page editor had remained at the previous larger size. When I deleted and reinserted the image, the handles were established at the new, smaller size.

I believe that Safari may render the image at the upper-left of the handles [0,0] whereas Indigo Touch may render the image at center of the handles.

Cheers,
Dave