Setting Parameters on Qubino 1d flush relay?

Posted on
Sat May 27, 2017 11:19 am
jester321 offline
Posts: 2
Joined: May 27, 2017

Setting Parameters on Qubino 1d flush relay?

Hi,

Im new to wave and Indigo so could be a total newb question..... I have installed the qubino relay and it works well but I don't want it to respond to the All On command. I know I need to change parameter 10 within the module but I cannot find anywhere in the Indigo software to allow me to change the value.

Any help appreciated.

Posted on
Sat May 27, 2017 11:53 am
CliveS offline
Posts: 211
Joined: Jan 10, 2016
Location: Medomsley, County Durham, UK

Re: Setting Parameters on Qubino 1d flush relay?

Go to Interfaces > Z-Wave > Modify Configuration Parameter, pick the Qubino 1d flush relay from the Device dropdown and put 10 in Param Index box. Read current value from device to setup the correct byte size for the Param Size and then change it to your value in the Param Value and then Save New Value and close.

CliveS

CliveS

Indigo 7.1.1 : Mac mini Server (Mid 2011) : MacOS Sierra 10.12.6

Posted on
Sun May 28, 2017 4:24 am
jester321 offline
Posts: 2
Joined: May 27, 2017

Re: Setting Parameters on Qubino 1d flush relay?

CliveS - you're a star! Thanks for the pointer.

Page 1 of 1

Who is online

Users browsing this forum: No registered users and 2 guests