[Resolved] Two devices, same address
Posted: Wed May 24, 2017 10:22 am
Hopefully posting in the correct forum...
I was debugging a z-wave range problem last night, and suddenly discovered that two devices I am trying to position specifically to act as long-range repeaters have ended up with the same address. Both are Fibaro FGS221, and I'm using an Aeotec Z-Stick Gen 2 with Indigo 7. See attached screen grab - the top two lines are one device, and the bottom two lines are another.
Any suggestions on how I can clear this up?
I was debugging a z-wave range problem last night, and suddenly discovered that two devices I am trying to position specifically to act as long-range repeaters have ended up with the same address. Both are Fibaro FGS221, and I'm using an Aeotec Z-Stick Gen 2 with Indigo 7. See attached screen grab - the top two lines are one device, and the bottom two lines are another.
Any suggestions on how I can clear this up?