So today they came and installed a new Air Conditioner and Furnace and replaced my Venstar thermostat with a Nexia 18-HD45D1-5 Thermostat that is supposed to be Z-Wave compatible. How can I add this / control it from Indigo?
Thanks!
Tim
Nexia Help
- Fxguy offline
- Posts: 153
- Joined: Mar 24, 2011
Nexia Help
- jay (support) offline
- Site Admin
-
- Posts: 18212
- Joined: Mar 19, 2008
- Location: Austin, Texas
Re: Nexia Help
If you already have a Z-Wave interface, then just add it as you would any other Z-Wave device.
- Fxguy offline
- Posts: 153
- Joined: Mar 24, 2011
Re: Nexia Help
Well that was easy! And the best part? No $9.99 per month fee! (Please don't switch to a subscription fee based software 
)
One last question, the new thermostat has a humidity sensor, any way to use that or display it in Indigo?
)One last question, the new thermostat has a humidity sensor, any way to use that or display it in Indigo?
- matt (support) offline
- Site Admin
-
- Posts: 21416
- Joined: Jan 27, 2003
- Location: Texas
Re: Nexia Help
Normally humidity automatically is added as a state for those thermostats. Press the Status Request button in the Main Window for the device, then copy/paste the Event Log results into a reply for me. Also open the device dialog, re-sync it, then copy/paste that log too.
- Fxguy offline
- Posts: 153
- Joined: Mar 24, 2011
Re: Nexia Help
NM. As soon as I posted I went back and saw the humidity value being displayed on my iPhone. What about outdoor temp? Can that be pulled in?
Who is online
Users browsing this forum: No registered users and 2 guests