I'm hoping you can help with this topic.
I'd like to use my vehicle's HomeLink to turn on Insteon devices (lights). I think I understand that the EZX10RF can receive the RF signal from the vehicle, then translate them to Insteon commands, which Indigo can respond to, and turn on the lights. Is the EZX10RF sending the Insteon commands over-the-air, through the power line, or both?
When I asked Smarthome support about the device, and what I want to do, they warned me about this setup:
...I would not recommend using it. Depending on the devices you have, you would be able to assign a x10 address to your Insteon device. However in doing that you turn that device into a x10 device which means the cons of using x10 comes into play such as the device turning on/off by itself.
Is this the case, even with Indigo? The way I read this post, and what the OP outlined, I'm not sure if Smarthome's warning applies.
Also, do I need any additional devices to be able to do this? I'm not currently using any X-10 devices, everything is Insteon, and my modem/main interface is the 2413U.
Thanks,
Rycardo