- Posted on
Sat Dec 15, 2018 3:47 pm
-
Unklmarty
offline
-
- Posts: 59
- Joined: Jun 30, 2006
- Location: NJ
-
Same problem here. I have 3 Remotelincs that will not define and sync. I am sitting right next to my Powerlinc 2414U and still it won't work. When I try to sync I hold down any button until the Remotelinc beeps and the led on the Remotelinc starts to blink, then my computer I click define and sync, then start. A box pops up with the message "Remote device "Black Remotelinc #1 is not responding. If this device is battery powered, then press and hold the set button to wake it up" Same thing for my other two Remorelincs. Because of this I can't define and sync nor can I add any responders. These devices were working fine a couple of years ago but were taken out of service when I replaced them with the mini remotes. I now want to add them back into my system but I can't. Yes all batteries are new and at full power. There is also a dual band Lamplinc (2457D2) and an Insteon range extender (2992-223) in the same room that I am trying to sync these devices.. When I press any buttons on any of the Remotelincs the action does show up in the event log e.g. Remotelinc #1 on (button 1). or Remotelinc #1 off (button 3) etc.
Any suggestions?