Insteon Low Voltage Contact Closure

I had this working around back as a sensor on my mailbox.... For some reason it stopped working


From trouble shooting I had sort of decided that it was the basis 2450 that died as Indigo couldn't communicate with it.


I want through my extras. Found one that Indigo could synch with.

The trouble is in bench testing it (just using two wires going to the GND and SENSE. I am getting no change is status whether I short the wires or not

I am assuming tha I am screwing up the device settings.... any suggestions??

[jay (support)]

I'm assuming you're talking about an I/O Linc. When you touch the two wires together, is the green LED coming on?

[MODERATOR NOTE] Moved to the Insteon forum.

It was not. so tried Anita I/O unit and this was the green light comes on when shorted and unit shows closed

when not closed the white led comes on and it show open


All is good in this part of the I/O world. just a couple more units for recycling


thanks for quick response