I have 4 doors with insteon locks and insteon open/close and lock/unlock sensors. When I manually lock / unlock ONE door the status gets properly transmitted and indigo shows everything nicely.
When I lock the doors electronically ( send insteon command to all lock mechanism) all doors lock at about the same time and all but ONE specific lock/unlock sensor signal never makes it to Indigo.
This happened after I replaced that one lock/unlock sensor.
So one after the other it works fine , all at the same time it worked but now not anymore after I replaced one sensor. the new one is firmware 34(i2sc engine) the others are 40(i2cs engine)
Any advice? Is there a way to change the sequence of signals .... or anything in insteon?
Karl
replacing them is a hassle (need to cut the board to make them fit.) ~ 2 hours of work