“can’t compare datetime.datetime to int” error during lime

Posted on
Mon Apr 25, 2016 3:40 am
durosity offline
User avatar
Posts: 2923
Joined: May 10, 2012
Location: Newcastle Upon Tyne, Ye Ol' England.

“can’t compare datetime.datetime to int” error during lime

Got a strange error today during Lime Protection:

Code: Select all
25 Apr 2016, 10:30:56
  Autolog Stella-Z                Lime Protection now in progress.
  Autolog Stella-Z Error          Error detected in Autolog Plugin runConcurrentThread Method 'E'
  Autolog Stella-Z Error            Error message: ''RelayDevice' object has no attribute 'hvacMode''

25 Apr 2016, 10:31:57
  Autolog Stella-Z Error          Error detected in Autolog Plugin runConcurrentThread Method 'E'
  Autolog Stella-Z Error            Error message: 'can't compare datetime.datetime to int'

25 Apr 2016, 10:32:58
  Autolog Stella-Z Error          Error detected in Autolog Plugin runConcurrentThread Method 'E'
  Autolog Stella-Z Error            Error message: 'can't compare datetime.datetime to int'

25 Apr 2016, 10:33:37
  Z-Wave                          received "Ensuite - Danfoss LC TRV" heat setpoint is 17.00 °C

25 Apr 2016, 10:33:57
  Z-Wave                          received "045 - Gym - Stella Z TRV" status update battery level 76%
  Autolog Stella-Z Error          Error detected in Autolog Plugin runConcurrentThread Method 'E'
  Autolog Stella-Z Error            Error message: 'can't compare datetime.datetime to int'

25 Apr 2016, 10:35:00
  Autolog Stella-Z Error          Error detected in Autolog Plugin runConcurrentThread Method 'E'
  Autolog Stella-Z Error            Error message: 'can't compare datetime.datetime to int'
  Autolog Stella-Z                Lime Protection now completed


Not sure if it actually ran it or not, and didn’t have a chance to turn on debug before it was finished. I can try it again manually if it’s needed.

Computer says no.

Posted on
Mon Apr 25, 2016 7:57 am
autolog offline
Posts: 1841
Joined: Sep 10, 2013
Location: West Sussex

Re: “can’t compare datetime.datetime to int” error during li

Has this only just started happening? If so, have you changed anything recently?

It looks like it is checking a relay device rather than a Stella-Z. It is possible this could be your boiler connect device?

I'll dig into it a bit deeper once I have some more info. :)

Posted on
Fri Apr 29, 2016 8:32 am
durosity offline
User avatar
Posts: 2923
Joined: May 10, 2012
Location: Newcastle Upon Tyne, Ye Ol' England.

Re: “can’t compare datetime.datetime to int” error during li

Nope, nothing that’s change in relation to that part of the system afaik. in fact very little changes anywhere in indigo. I’ve not seen the error before but then if it only happens once a week during the day when i’m usually at work it’s unlikely i would have seen it. When i’m back home i’ll turn on debug logging and try to run a manual one, see if it does the same.

Computer says no.

Page 1 of 1

Who is online

Users browsing this forum: No registered users and 1 guest