Hi Everyone,
Dowloaded the indigo software on trial and I am beginning to start set -up. I order numerous sensors from monoprice and I am learning as I add them.
I am worried that my question must be something very basic that I am missing.
I purchased 15 of the following window/door sensors.
https://www.monoprice.com/category?c_id ... id=1091804
I was able to associate with controller and it appears in indigo, but the only thing I can get is battery level. When I remove magnet statuses never change.
I can not figure out if I need to edit something to define as window sensor.
I have been reading through wiki's, but just not picking up on what I need to do.
Dec 16, 2017 at 8:20:33 PM
Z-Wave Indigo Device "011 - Notification Sensor" Z-Wave Properties:
Indigo Z-Wave Version: 2.0.111
Node ID: 11
Model: Notification Sensor
Model ID: 02010008
Manufacturer: Unknown
Manufacturer ID: 0208
Protocol Version: 4.34
Application Version: 1.04
Model Definition Version: 0
Library Type: 3
Class Name: Notification Sensor
Class Hierarchy: 04 : 07 : 01
Command Class Base: 00
Command Versions: 20v1 80v1 84v2 85v1 86v1 70v1 71v1 72v1 73v1 98v1 59v1 7Av1 5Av1 5Ev1
Encryption Status: Supported but not Enabled
Multi-Endpoint Types: - none -
Multi-Endpoint Classes: - none -
Multi-Instance Counts: - none -
Features: routing, battery, beaming, security, waking
Neighbors: - none -
Associations: 1:[1] 2:[]
Config Values: - none -
Dec 16, 2017 at 8:02:47 PM
Z-Wave sent "011 - Notification Sensor" status request
Z-Wave received "011 - Notification Sensor" status update battery level 100%