FGMS-001 units are changing

I have one of these in my hallway for motion detection as well for switching the light.
Actually is working quite well.

But since a while I've observed that (mostly by night) the device is constantly changing the units (luminance, temperature, etc.)
Why does this happen?

Yassi

[matt (support)]

Interesting. Does it look like that happens every time the module broadcasts out its temperature sensor and light sensor values?

My guess is the module is sending both °C and °F (and for lux + % for the light sensor). Indigo auto detects the units sent for any given sensor and switches over to use those units. That is, it expects a sensor to send only a single type of value, not multiple. I've never seen a module send multiple before.

matt, I also can't remember it switched them in the past.

As far the sensor remains on the "right" unit it's ok.
Otherwise, I suppose it will bring my stuff to a mayhem situation


Sent from my iPhone using Tapatalk

I assume there's a setting to toggle between the two? perhaps try setting it to whatever it's not set to, sync it, then set it back?

I have to check this.
Strange is, I can't remember I've seen this before.
For a while the communication to the device was disabled due to my move to another house.


Sent from my iPhone using Tapatalk