Trane XR524 - Adjust Sensor Calibration via Z-wave?

I have two Trane XR524 thermostats and would like to sync the sensor calibration with readings from Zooz 4 in 1 sensors throughout the home. Is it possible to adjust this value via a Z-wave parameter update?

Thanks!

[matt (support)]

I don't believe that thermostat has any type of internal calibration parameter. Take a look at the very handy Adapters Plugin – it should let you create a virtual sensor device that has the calibrated value.

Thanks Matt! I went another direction. While it is possible to adjust the thermostat calibration from the panel directly, I decided that doing so (whether directly or programmatically) would cause issues and erratic behavior during different seasons. Instead, I am now looking at data from multiple temperature sensors and performing calculations on these data to determine when to turn the thermostat on and off. So far so good!