I successfully added the shades to the Z-Wave network and can control them with indigo using 0-100% brightness settings. The problem that I run into though is that with the layered shades the 0-100% control increments are not accurate enough, e.g. 2% is too much closed and 3% is too much opened. I theoretically would need to set the level to e.g. 2.5% - which indigo does not support. I can set the exact open position that I want to achieve with the shade's Z-wave remote that is also part of the network. Looking at the event log I can see the command that the remote is sending to the shades:
Z-Wave Debug RCVD sceneActivateCmd2: 01 0B 00 04 00 03 05 5B 03 FF 02 03 50
Z-Wave Debug . . sceneActivateCmd2: node 003, type: 2, scene: 3
Z-Wave received "Primary Remote Office Blinds " scene 515
Z-Wave Debug RCVD sceneActivateCmd2: 01 0B 00 04 00 03 05 5B 03 00 01 03 AC
Z-Wave Debug . . sceneActivateCmd2: node 003, type: 1, scene: 3
Z-Wave received "Primary Remote Office Blinds " scene 259
Is there a way to duplicate this command with indigo? I tried reading through numerous Z-wave threads but couldn't find anything on sending such a command to the device.