Fibaro Roller Shutter - Venetian

[matt (support)]

However if I fully open the covering it goes down a bit to close the lamella position. So if I set the brightness to 100 Indigo should automatically set the lamellas to open. I am be able to do this with triggers. Since I only want the lamellas to be tilt if closed this is pretty easy.

Can you describe in more details what you mean here? That is, what occurs and what specifically would Indigo need to do if we implemented these commands in the UI?

I have found the perfect solution for me:

Make triggers for 0%, 4% and 100%.

When on 0% send RAW command to fully close the lamellas (0), on 4% set them to 50 and on anything else set it to fully open (99).

4% I use when I want some fresh air, but it still should be protecting from rain. I only use this when the shutters are almost closed.
So I just have three positions of the lamellas and can position everywhere and it does not set the lamellas vertical when fully open (and therefore comes down a few centimeters).

Might help someone else.

[matt (support)]

Great tip.