Celcius for Thermostat Set Points

Hi,

I'm running some Danfos z-wave thermostats and now that they are supported by Indigo I can control the heat set point. Which is great, except the interface to change it is only in Fahrenheit. On the device summary at the bottom of the main window the set point is reported in C, but the dialogs on the trigger and action group pages are in F.

Have I missed something? Or can I request that C be supported on these dialogs in the future.

Thanks,

Nic

[matt (support)]

Hi Nic,

Which specific UI are you referring to? Can you take a screen shot of it and post it?

OK, so now I see that Fahrenheit isn't explicitly called out, but the default value is 70... Leading me to assume its F

ThermoDialog.jpg (75.44 KiB) Viewed 1062 times

Is it just a value, not specific to F or C?

[matt (support)]

It is just a value. On initial launch it defaults to 70 (and 78 for cool setpoint, I think), but once you change the UI that will become the new default setting, I believe.