PRoblem with plugin and RFXtrx

Hi,

I'm hoping someone here can help me. I have indigo 6 installed as a trial with the RFXCOM plugin. I also have a RFXtrx 433MHx transceiver attached with serial driver and plugin installed.

I am receiving temperature status fine from a couple of Oregon Scientific thermometers.

I have tried to set up some homeeasy device switches (Type HE331W) but cannot get the switches to recognise the signal from the RFXtrx when the switches are in learn mode.

This is the log:

RFXCOM Debug sent "Test" on
RFXCOM Debug Actions...TurnOff
RFXCOM Debug Turn HEAppliance Appliance/Dimmer Off (level 0).
RFXCOM Debug Address 12345678
RFXCOM Debug housecode:1
RFXCOM Debug device type:HEAppliance
RFXCOM Debug device type:1
RFXCOM Debug device level:0.0
RFXCOM Debug send x10 cmd: 11 17 1 0 18 52 86 120 1 0 0 0 (0B 11 01 00 12 34 56 78 01 00 00 00)
RFXCOM Debug processing: 4 2 1 0 0 (04 02 01 00 00)
RFXCOM Debug ACK Message ACK, transmit OK

Anyone got any tips or pointers as to where I am going wrong?

Thanks

That was the off log, this is the on log, still not working though!


RFXCOM Debug Turn HEAppliance Appliance/Dimmer On (level 0).
RFXCOM Debug Address 12345678
RFXCOM Debug housecode:1
RFXCOM Debug device type:HEAppliance
RFXCOM Debug device type:1
RFXCOM Debug device level:0.0
RFXCOM Debug send x10 cmd: 11 17 1 0 18 52 86 120 1 1 0 0 (0B 11 01 00 12 34 56 78 01 01 00 00)
RFXCOM Debug processing: 4 2 1 0 0 (04 02 01 00 00)
RFXCOM Debug ACK Message ACK, transmit OK
RFXCOM Debug ++++++++++++++
RFXCOM Debug sent "Test" on

There is a difference between HomeEasy, KlikAanKlikUit, NEXA, Chacon, Intertechno (AC protocol) and HomeEasy EU (HE EU protocol) modules.

Use the AC protocol for HomeEasy UK modules.
Use the HE EU protocol for HomeEasy EU modules.

Thanks for the tip, works perfectly now!