I have a few RollerTrol blinds motors that I would like to automate with an RFXtrx. They operate under the native BlindT0 protocol. I checked your plug-in implementation, but I'm not an expert in XML and Python to rapidly add support for blinds in your Indigo plug-in. Can you pinpoint me where shall I make modifications to achieve basic ON/OFF (Open / Close) functions? I could even send the raw IR code data... =-)
Thanks,
Sylvain
p.s. Here's the output from TRXmng while pressing on the remote to close blind unit 1 and 2.
- Code: Select all
================================================
Set Mode:0D 00 00 02 03 53 00 00 40 00 00 00 00 00
------------------------------------------------
0D01000203532D00400001000000
Packettype = Interface Message
subtype = Interface Response
Sequence nbr = 2
response on cmnd = Set Mode
Transceiver type = 433.92MHz
Firmware version = 45
Hardware version = 1.0
Undec off
X10 disabled
ARC disabled
AC disabled
HomeEasy EU disabled
Meiantech disabled
Oregon Scientific disabled
ATI disabled
Visonic disabled
Mertik disabled
AD disabled
Hideki disabled
La Crosse disabled
FS20 disabled
ProGuard disabled
BlindsT0 enabled
BlindsT1 disabled
AE disabled
RUBiCSON disabled
FineOffset disabled
RFU protocol 3 disabled
RFU protocol 4 disabled
RFU protocol 5 disabled
RFU protocol 6 disabled
------------------------------------------------
0919000000C29F020170
Packettype = BLINDS1
subtype = Safy / RollerTrol / Hasta new
Sequence nbr = 0
id1-3 = 00C29F
Unit = 2
Command = Close
Signal level = 7
------------------------------------------------
0919000100C29F010170
Packettype = BLINDS1
subtype = Safy / RollerTrol / Hasta new
Sequence nbr = 1
id1-3 = 00C29F
Unit = 1
Command = Close
Signal level = 7