Bond Plugin - Firmware V3

[FlyingDiver]

The Bond Hub is supposed to send out updates whenever any device changes. This line is where the listener for those updates is started:

Code: Select all

   Bond Home Debug                 udp_start() socket listener started

I wanted to see if you're getting ANY updates from the hub, which is why I asked you to try to change a device using the original remote or the Bond app.

Currently, the plugin uses those updates to set device states, not the commands it's sending out. That SHOULD be a more accurate representation of the device. But if you're not getting ANY updates, then there's something else going on.

I'll try to look into it this weekend.

[ppespepe]

Thanks, Joe!

Right you are. I'm not getting any updates according to the log window.

I know the HUB is sending the info out. Below is a log output from a different automation software in case it helps in any way.

2022-08-12_15-14-57.png (166.49 KiB) Viewed 1171 times

KR

PP