This is for 0.14 RC 6.
I have a wrapper device that I've set up as a switch. The on and off operations map to action groups. The on and off states map to another device's on and off state. The status settings don't seem to be saved properly
Here's the before picture for the "on" state:
When I then go check the device settings either the On or Off status has lost the setting to the device it was using:
Sometimes it shows up but usually it doesn't. It's usually the "on" side that has the problem but not always.
The device I'm using the status from is a Device Group from the Indigo Virtual Device.
The action group portion of the config seems to work fine. It's only the status side that seems to have problems. This is my first attempt with Wrapper devices so it's possible I'm doing something wrong but I think I've got it right. I enabled debugging in the HBB settings but don't see anything useful in the log that might help.
Any ideas?