Hello,
I have a module in my shower that runs a little web server. It has ssh but no idea what the username and password is. I might be able to figure that bit out though.
In the mean time, i have tried running a packet capture to see if i can see http post when i set temp and on/off commands via my browser but looks like it is javascript not strait up html.
Any ideas on how i can get to a point where i can control this device via indigo... i know its a massive open question, just looking for some ideas as i have put off this for a few years now hoping this model might become more mainstream but alas no.
In fact i think i may even have a bloody prototype wifi/web server module as it came with a module (which i still have, resembles and ESP8266) which only spoke to a cloud service and a p*ss poor app, which they pulled then re-added to the appstore. In the middle of that i was sent a new model which support have never heard of and now just ignore me.
Anyway, any ideas to get to control/read any data from this module would be helpful. I rarely use the wifi to do anything with the show but that is because its a faf to get out the phone instead of it pre-heat as i open the bathroom door say before 8am but after 4am... it only pre-heats, it does not stay on for more than 20 seconds when enabled via the web page.
It does have some features id like to read like water consumption, temp, if it is on or off (then i can have the extractor tur on based on the shower being on) etc...