Indigo Domotics

Greetings - I use X10 motion sensors. Under Devices in Indigo Touch they are all listed in red and as '-interface disabled-'. They all werk fine and have Comm and Remote Display enabled. Can you tell me why they are all listed in red and as 'interface disabled'.

thanks to you,

Z

At the bottom left of the screen, next to the activity bar that shows green/purple blobs of activity being sent/received, it should show a list of which interfaces you have enabled.

Does X10 appear there?

If not, go to the menu > interfaces > X10/Powerline and enable the interface.

If it's already there but red with strikethrough, your interface (CM15?) isn't being detected by Indigo.

The W800RF32 is listed as an enabled interface in Indigo so it is being detected by Indigo. If the W800RF32 had a red line through it my motion sensors vouldn't be working. It is only on my iPad with Indigo Touch 2.0.5 under DEVICES that my X10 motion sensors have the label in red and underneath the label it says -interface disabled- also in red.

thanks to you,

Zurich

Sounds like a buglet. We'll look into it.

Just thought I would throw w me too


6.1.2 indico server running on os 10.10 Touch on IOS 8.4

bump. I have still have this situation with indigo 6.1.1 -current Verizon of touch

Still on the list to look into. Duplicate posts won't make it happen any sooner.

I am sorry about duplicate but the last chain said "answered" which I assuemd was same as solved

We hope to have this fixed in Indigo 7.0.3. Luckily, it is something that I believe can be fixed in Indigo Server (versus Indigo Touch which we will be working on in the nearish future).

Great news.

captcurrent wrote:

I am sorry about duplicate but the last chain said "answered" which I assuemd was same as solved

We use SOLVED and ANSWERED somewhat interchangeably, but SOLVED should mean it's fixed and ANSWERED may not mean there's a fix yet but that we've answered the OP question.

Indigo v7.0.3 is now available and fixes the UI display bug that causes Indigo Touch to display "interface disabled" for X10 RF modules when using a W800RF32 or MR26.