Ecolink ZWave Garage Door Sensor and Garage Door+.png

I have an Ecolink TILT-ZWAVE2 sensor on my garage door. When I connect it to a Control Page using the "Garage Door+.png" image, the status is reversed. "Open" means the sensor is off and the garage door is closed and vice versa. How do I reverse the logic here so the display is accurate?

Could just reverse the image names. There should be some other way but I dont know
what it would be,

Carl

That's what I ended up doing...
/Library/Application\ Support/Perceptive\ Automation/Indigo\ 6/IndigoWebServer/images/controls/devices/Garage Door+off.png
becomes
/Library/Application\ Support/Perceptive\ Automation/Indigo\ 6/IndigoWebServer/images/controls/devices/Garage Door+on.png
And vice versa.

However, that seems a bit hacky and is a "configuration" that is likely to be undone with the next release. It would be better to be able to have configuration capability at the Control Page setup.

Could just reverse the image names. There should be some other way but I dont know
what it would be,

However, that seems a bit hacky and is a "configuration" that is likely to be undone with the next release. It would be better to be able to have configuration capability at the Control Page setup.

You can take it one step further by creating a copy of the image files and renaming them to something that won't be undone.

myGarageDoor+.png
myGarageDoor+open.png

Dave